Online Technical Help

Directions to Replace an Epson Stylus NX300 Toner

October 10 2016 , Written by Lisa Heydon Published on #Printer

Directions to Replace an Epson Stylus NX300 Toner

If you are trying to print a photo or document on the Epson Stylus NX300 and it displays you an error message on the screen that one of the ink cartridges is empty or low, you need to replace the ink cartridge to continue printing. While an ink cartridge is a thick or having blockage, you may face printing issues like faded, washed or missing colors. So, replace an empty or low cartridges can fix the error and make your Stylus NX300 to operate normally. At the same time, if you are unable to handle it properly, you can contact the Epson printer technical support number to avail instant support.

Step 1:

At first, see the message shown on the printer screen. Press the ‘OK’ button located on the Control Panel of the printer to fix the error.

Step 2:

Put your hands in the depressions on the scanner bed sides, and lift up to uncover the top half of the printer to open thelocation. Now, you should check the carrier for the ink cartridge on the printer right side.

Step 3:

Put your hands in the depression on the ink cartridge carrierback side. Swipe the cover up and near you to release it.

Step 4:

Press the release lever on the empty cartridge back side, and swipe the cartridge up to take away it from the carrier.

Step 5:

Shake the new tonergradually to allot the ink inside it, and then take it outfrom its foil package. Cover the protective film off of the bottom and sides of the toner; be careful not to use the nozzle or electronic components.

Step 6:

Turn the ink cartridge, thus the nozzle surfaces down and the release leversurfaces away from you. Lower the toner into the empty slot on the carrier unless the release lever connects.

Step 7:

Place the cover for the cartridge carrier to its proper place, and lower the top of your printer to close it.

Step 8:

Press the ‘OK’ button on the printer control panel, and wait for the screen to show a message telling you that the Stylus NX300 printer is ready to use. Press the ‘Menu’ button to remove the message and continue using the printer.

However, if you are unable to replace your Epson Stylus NX300 toner even after putting a lot of efforts, you can call on the Epson customer service phone number and ask the help of experts to fix the problems.

Share this post

Repost 0
To be informed of the latest articles, subscribe:

Comment on this post